Raspbery Pi DMP issue and general question
Hi, I have built my cat and it is working without a Raspberry Pi. Now I want to add my RPi4. I followed the instructions in the hardware forum (How to set up Raspberry Pi for programming Nybble). I have connected up the Pi, flipped the I2C switch (SW2) to Pi, and turned everything on. I connect to the Pi using VNC Viewer and run the Arduino IDE. In the serial monitor I see the following scrolling repeatedly:
Initialize DMP
Checking hardware revision...
Revision @ user[16][6] = 0
Resetting memory bank selection to 0...
1567 -24 1 33
DMP failed (code 1)
Can anyone tell me how to fix this? Of course I am using a RPi4 so that might be causing a problem. Also, the IDE version is 1.8.12, not 1.8.8 as mentioned in the hardware post.
My general question is, once I have the Pi properly connected, will the IR remote still work or can I only control the cat through the RPi? My goal is to write python code to tell the cat what to do, but it will take me a while to get there, I suspect.
Thanks! Chris
Great project by the way, and I am happy it comes from a Wake grad! I worked at Wake Forest on and off for 17 years.
@R T After you dial the switch to Pi, the master of the I2C network becomes the Pi. The servo pins are not connected to the Arduino or the Pi, but a servo driver PCA9685. It communicates with the master through I2C. So you need to use the Adafruit PCA9685 PWM library on the Pi to drive the servos.