Hello, I have successfully finished the Calibration set up of my Nybble, and have successfully passed the Validation check out by writing "d" and "kbalance" to make sure the calibration is correct, and it is. Thank you for sending a new servo!! The issue is that when I upload and run the "Nybble", it seems to be running correctly and i get the final ""avdude done. Thank You" message in red, but then the nybble starts making a sound that does not stop. When I tried launching the board, I was getting the numbers that you see in the video. what am I doing wrong can how can I do it correctly? Thank you!

Hi, One of the knee joints of my nybble (c15) does not seem to be responding to the calibration codes in the serial monitor. All body parts were attached to the servos only after calibration command (c), but still, this one limb is stuck. How can this be fixed?