I saw that, but it goes right from cabling to calibration. Nothing about software to use and how to use that software. Did I miss something? By the way, I really do appreciate all your effort on the project and your responses to my posts. When I got this via Kickstarter, it seemed to be for people who aren't professional coders, so I got it for my son and me to do together. Neither of us are very good with coding, so we hope there's an answer we can handle.

Nothing on that page except a reference to the forum. I searched the forum for how to get started with coding and couldn't find anything basic. It's all very advanced.

That is VERY helpful, thanks! In the second diagram (the drawing), what's the difference between the red and gray numbers? Also, how can I tell if I have a V0_2 board?

Also, my cat shipped a couple more of B screws. How can I get those?

Are there instructions for connecting the cable and what to do with the board where the sketch uploader (FTDI) attaches? Does the connector get wrapped up towards the top of the caty or does it face the bottom?

I am trying to put the Nyboard onto the body and cannot find directions how to install it, specifically, which screws to use and from which direction to screw them in. I also have no idea where to put the sketch uploader. Is there a complete set of instructions or videos that explain that and how to attach the servos to the nyboard?

The animation is different from the video of you putting it together. Are there instructors for the pieces that match the set I was sent? The videos I've seen don't include where the wires should go.

But the pieces that hold the servos at the end don't match your video. The wood with the battery on it is too narrow for the piece it gets attached to. See photos. the bottom holes on this one are big enough for the piece that holds the battery

Is there a video with the wires in them? I don't know where they go while I'm assembling...