top of page
Forum Posts
Ryan Barry
May 24, 2021
In General Discussions
Any chance there's a place for me to grab the 3d file of the Bittle backplate for printing? I want to create a plate with a spot for the OLED to sit in without having to print multiple iterations trying to match up dimensions. I found the neck joint file which was super helpful but no luck on the back plate! Thank you!
0
2
76
Ryan Barry
May 22, 2021
In Hardware
I recently purchased the MU Vision sensor off ebay, but it came with a 4pin connector to 4 female jumper wires instead of the 4pin to the 4pin connector. I have a few seeed modules that have the correct cables so I tried those but had no luck. Can anyone direct me to the correct cord so I can try out the MU Vision Sensor 3 with my bittle. Thank you!
0
7
433
Ryan Barry
More actions
bottom of page