Hallo.
ich habe ein neues NyBoard V1. Gibt es hierzu eine detaillierte deutsche Installationsanleitung die den Prozess Schritt für Schritt erklärt. Ich habe die Katze mit dem 3D Drucker ausgedruckt und bereits montiert. Jetzt fehlt noch die Elektronik. Wie ist die Vorgehensweise. Wird erst die Software aufgespielt, erst die Verkabelung vorgenommen- was ist wie zu tun?
Welche Spannungsversorgung ist die sinnvollste?
Danke und Gruß
Its a very nice Cat, thanks for it, yes, it works in the normal state. But its not my opinion to work in the normal state, i think i have a lot of work/fun with this monster. I, my grand son and my both cats.
I have a robot car that drives autonome in my house and i think it was the future of the cat. At first the ultrasonic sensor must work to correct the way between chairs, table and so on. May be a project for a couple of months, just right in the times of corona.