Hi, Just assembled Bittle up to paragraph #4 Board Configure. I downloaded the apps
1. Arduino - when opened, headline reads “sketch_may27d | Arduino 1.8.19.”
2. OpenCat.ino - when opened headline reads “OpenCat | Arduino 1.8.19”
If I read correctly, I skip paragraphs 4.2.1 and 4.2.2 (bracketed with brown line).
Paragraph 4.2.3 shows Arduino file opened with headline reading “Arduino File Edit Sketch Tools Help”.
How do I get there. What file(s) am I missing?
Searching the Forum, YouTube videos etc has not helped so basically “stuck” at paragraph 4.2.3. Any help would be appreciated. I have basically no programming experience. My desktop is an iMac.
I was gone from my computer for past three hours, therefore Lark access codes expired. Please send again. Thanx.