Hello, I apologize if this is a repeat, but I'm having trouble viewing the previous posts. I have built and calibrated my Nybble on the v2 board. I can successfully run WriteInstinct.ino and Nybble.ino, and send commands via the serial monitor. The I was able to use the remote to execute commands earlier. I performed a final calibration, and now the remote fails to execute commands. I have: 1. uploaded Nybble.ino 2. executed commands via serial monitor 3. uploaded testInfraredRemote 4. The serial monitor displays: ``` 13:36:41.639 -> IR Receiver Button Decode ```` 5. When I press any button on the remote, nothing is displayed. 6. I have replaced the battery on the remote as well. What are other troubleshooting steps that I can take?