Hi, I am building a bittle which uses a biboard!
I cannot see a revision number on the board so uncertain as which bi board I have!!!!
My problem is that I am unclear on how to physically connect the servos!
There are 4 blocks of pins with a 3x3 layout,but no indication of orientation??
Do the srvo cables connect vertically or horizontally & are they ordered from top to bottom or vv or if vertically which side to side??
I don't want to burn out myservos by connecting them incorrectly so am stuck until I get some guidance!!
Thanks
Tom Connell
Moving on from that my servos do not have a brown they have black red and white!! I assumed rightly or wrongly that black=brown!
The head servo is working so i assume that is correct!
None of the other servos seem to working, by that I mean they do move when powered on but do not seem to respond to the +/- slider in the config!! Tried with the petoi app on both a tablet and a phone!!
Need to strip it down again to check the wiring is ok, but is there an easy way to determine if the servos are OK?
Thanks
Tom