Hello, I try to calibrate nybble (board V0_2) but when I finish, I enter the kbalance command but nybble does not raise it seems he is stuck and I have to take in the hand to see servos moving. You can see it in video:
Does someone know what is the issue, please? Do I have missed something?
Thanks
Thanks a lot for your response the battery have a flat head and I think it was not correctly in contact nyble now walk a little bit but I have not yet screw the part so I will try to recalibrate screw it and make a new test I will let you know it was good :)
Thanks, when I send "kwkF" the cat perform well a periodic walking pattern but when I put it on the desk nybble do not walk
video
And when I turn on the gyro the motion decelerate
Unfortunately, I can't measure the voltage of the batterie I don't have a Multimeter
If you send the walking command, i.e. "kwkF" or "ktrF" through serial or through the app, does the cat perform a periodic walking pattern? If you turn on/off the gyro (command "g"), does the motion decelerate/accelerate? What's the current voltage of the batteries?
Hello, yes when I hold nybble in the air legs can move. this is the
battery photo:
Do you have a picture of the batteries showing the voltage and capacity? If you hold Nybble in the air and type other commands like c or d, does it move?