Hi
Trying to connect NyBoard to my computer to upload sketch and software but keep getting the overcurrent protection (Rx led does not turn off and port not opening on the IDE). Tried every solution I could find on the web: changing USB port, updating driver, connecting battery alongside USB etc.... no luck.
Is there anything else that can be done?
Thanks
Ofer
If the USB overcurrent protection is triggered, you should also see a notification from Windows.
The connection looks correct. And the LEDs are lighting correctly. Do you have a video to show how the board starts when you connect the cable, and how the servos rotate? Does the buzzer beep?
I think the NyBoard is good, and it's still a problem in the configuration of the serial programmer. Closeup pictures of both sides of the NyBoard will help to confirm that.