Basic Assembly and Setup

So , after configuring the board pressing EQ does nothing when trying to calibrate.

What I have done so far:

I downloaded the opencat from github as a zip, unzipped the folder and renamed it to OpenCat.

tried the buzzer - it gives me a little melody and I see responses through the monitor.

checked library versions - IRRemote is 2.6.1.

uploaded infrared test sketch - this works fine, I can see responses from the serial monitor.

Is it possible there is something going wrong with the Opencat.ino installation? I see a frightful number of red notes and warnings when the sketch gets compiled.

The buzzer gives a lot of clicks and then nothing.

Serial monitor gives me this:

* Start *

Initialize I2C

Connect MPU6050

Test connection

MPU successful

Initialize DMP

-1 -1 -1 -1

Enable DMP

Enable interrupt

DMP ready!

* Assigning 1 skill addresses...

Can someone comfirm this is OK or if not, what steps I can take to solve the issue? Thanks in advance.