Voice Module failed?
The voice module has been working fine since I built the kit in early October.
Most recently last night. But this morning when I tested before taking Nybble to show some friends there was no response from any voice command.
IR remote worked fine.
Nybble startup shows:
Init voice
Customized voice:
10
Ready!
The voice module has a red LED that is lit. The cable appears to be plugged in at each end.
Has anyone else experienced a failure of the voice module?
Thanks, Burt
53 Views
The voice command module gets the voice translated to text command. It runs on a separate chip as long as it's powered. In some cases, it may get stuck, and you can use the serial command introduced in the user manual to reactivate it. Usually, switching between languages should work.
Update: The problem has been resolved using the above method.