Hardware

Hey I have the "cyberEye v1.2" from the Bittle Sensor pack: https://www.seeedstudio.com/CH-Bittle-p-4922.html

This is the same MuVision Sensor 3 however without the dip switches to change modes. I was able to flash the latest firmware v1.1.5 to it, but it only comes up in I2C mode. Is there any other way to configure it? Better yet does anyone happen to know what the camera is? I don't really need the built-in recognition and could make use of it as a regular ESP32.

Low expectations but high hopes! :)